S T E A K

Big L

Cheesehead
Joined
Sep 10, 2021
Messages
2,240
Reaction score
1,073
This is for a good cut of steak - Ribeye - Tenderloin - Porterhouse etc.

if you don’t have a big cast iron skillet, invest in one if just for steak alone, and also get yourself an instant read thermometer as cooking is all about internal temperature more so than anything else.

I do not tenderize to any great extent a good quality steak, other than briefly with my needle tenderizer, if at all.

Make sure your steak is at or close to room temperature before adding your seasoning which for me is either a blend - salt 1 part / granulated garlic 1/2 part or a good quality steak seasoning like Montreal etc. and pat it in firmly. I add my black pepper on both sides once the steak is pulled and while resting to avoid the pepper from burning and it is so good added just before the approx 6-7 minute rest period.

Apply seasoning liberally ( Don’t go nuts )

Turn your oven to preheat at 350 degrees and then place your cast iron skillet in the oven with 2 tablespoons of oil

On your stove place 2 tablespoons of oil in a fry pan and bring it up to a medium high heat. It has to be hot enough to get that steak sizzling and seared. Once to temperature, add your steak or steaks and then immediately add 2 tablespoons of butter. Slide your steak or steaks around while basting with the butter several times and then flip after about 2-2 1/2 minutes, and repeat. The amount of sear is up to you, just pay attention as to not over-sear.

Now open the oven, add 2 tablespoons butter to the cast iron skillet and add your steak or steaks. Close the oven and continue cooking until the internal temp is 5 degrees below your desired doneness. You can look up the temps for for your desired med rare, med etc. Another thing that everyone should have is an instant read thermometer (I know I repeated this). Add a nice pat of butter and put on a warmed plate or platter loosely tented with foil for the approximately 6-7 minutes of rest time.

if you want to use the cast iron pan on the stove top and in the oven, pull off the burner after the initial searing, put the steaks loosely covered on a plate or platter, lightly wipe out the old grease and butter ( don’t need to go overboard doing this) add 2 more tablespoons of oil and butter place the steaks back into the cast iron skillet after allowing the cast iron skillet to cool for about 5 minutes and then into the preheated oven.
 

AmishMafia

Cheesehead
Joined
Sep 27, 2010
Messages
7,948
Reaction score
3,239
Location
PENDING
I use something similar to this method in bad weather, but usually it's on the grill. A few chunks of Applewood, and I am set.

One point i would add is the salt on the steak should be at least an hour before cooking, sometimes I do it 5 or 6 hours. The salt draws out moisture which is then reabsorbed into the meat after an hour or so. You want that moisture back in the steak. It takes with it the salt and any seasoning into the steak. Pat dry before searing. This is the best way to promote the Millard reaction.
 
OP
OP
Big L

Big L

Cheesehead
Joined
Sep 10, 2021
Messages
2,240
Reaction score
1,073
I use something similar to this method in bad weather, but usually it's on the grill. A few chunks of Applewood, and I am set.

One point i would add is the salt on the steak should be at least an hour before cooking, sometimes I do it 5 or 6 hours. The salt draws out moisture which is then reabsorbed into the meat after an hour or so. You want that moisture back in the steak. It takes with it the salt and any seasoning into the steak. Pat dry before searing. This is the best way to promote the Millard reaction.
I will not risk over salting a good cut of meat. Do the great restaurants salt their steaks an hour or 5 or 6 hours in advance, the answer is no. The initial seasoning and basting in butter before it goes into the oven gives a great flavor and lets the meat be the star of the show. When I smoke large cuts of meat like pork shoulder, ribs or brisket then I will use my rub, refrigerate over night and then let it sit out for about an hour covered before throwing it on my smoker.

But to each their own
 
Joined
Aug 16, 2014
Messages
22,295
Reaction score
11,812
This is for a good cut of steak - Ribeye - Tenderloin - Porterhouse etc.

if you don’t have a big cast iron skillet, invest in one if just for steak alone, and also get yourself an instant read thermometer as cooking is all about internal temperature more so than anything else.

I do not tenderize to any great extent a good quality steak, other than briefly with my needle tenderizer, if at all.

Make sure your steak is at or close to room temperature before adding your seasoning which for me is either a blend - salt 1 part / granulated garlic 1/2 part or a good quality steak seasoning like Montreal etc. and pat it in firmly. I add my black pepper on both sides once the steak is pulled and while resting to avoid the pepper from burning and it is so good added just before the approx 6-7 minute rest period.

Apply seasoning liberally ( Don’t go nuts )

Turn your oven to preheat at 350 degrees and then place your cast iron skillet in the oven with 2 tablespoons of oil

On your stove place 2 tablespoons of oil in a fry pan and bring it up to a medium high heat. It has to be hot enough to get that steak sizzling and seared. Once to temperature, add your steak or steaks and then immediately add 2 tablespoons of butter. Slide your steak or steaks around while basting with the butter several times and then flip after about 2-2 1/2 minutes, and repeat. The amount of sear is up to you, just pay attention as to not over-sear.

Now open the oven, add 2 tablespoons butter to the cast iron skillet and add your steak or steaks. Close the oven and continue cooking until the internal temp is 5 degrees below your desired doneness. You can look up the temps for for your desired med rare, med etc. Another thing that everyone should have is an instant read thermometer (I know I repeated this). Add a nice pat of butter and put on a warmed plate or platter loosely tented with foil for the approximately 6-7 minutes of rest time.

if you want to use the cast iron pan on the stove top and in the oven, pull off the burner after the initial searing, put the steaks loosely covered on a plate or platter, lightly wipe out the old grease and butter ( don’t need to go overboard doing this) add 2 more tablespoons of oil and butter place the steaks back into the cast iron skillet after allowing the cast iron skillet to cool for about 5 minutes and then into the preheated oven.
I need to get that thermometer. That’s the 3rd time I’ve heard that recommendation recently and I just need to buy one. It’s probably a reason I often overcook or undercook.
Thanks sounds delich
 

Voyageur

Cheesehead
Joined
Nov 10, 2021
Messages
4,536
Reaction score
4,288
We sous vide steaks in cold weather. Just started doing it and they're fantastic. A lot of top steak houses throughout the US employs this technique. The first time out it was great, and the second time fantastic because we got the wrinkles out of how we were doing it.

It's also a great way to take a cheaper and tougher piece of meat and turning it into a tender morsel.
 

El Guapo

Cheesehead
Joined
Dec 7, 2011
Messages
7,560
Reaction score
3,031
Location
Land 'O Lakes
A few years ago I read a cooking magazine. The article that caught my eye was about steaks. It's the cast iron method but with frozen steaks.

Pre-heat the oven to 300. Pre-heat cast iron pan on stove top. Add high-temp oil (like avocado) to pan. Pull steak out of freezer and put immediately into pan. Sear for 60-90sec on each side, depending on the sear that you want. Then season liberally with SPG and shove in the oven until desired doneness.

The first time I made this was for my brother at my cabin. He flipped out over it. I was shocked at how good a frozen steak cooked this way. Seeing is believing but there are many ways to skin a cat.
 

Voyageur

Cheesehead
Joined
Nov 10, 2021
Messages
4,536
Reaction score
4,288
A few years ago I read a cooking magazine. The article that caught my eye was about steaks. It's the cast iron method but with frozen steaks.

Pre-heat the oven to 300. Pre-heat cast iron pan on stove top. Add high-temp oil (like avocado) to pan. Pull steak out of freezer and put immediately into pan. Sear for 60-90sec on each side, depending on the sear that you want. Then season liberally with SPG and shove in the oven until desired doneness.

The first time I made this was for my brother at my cabin. He flipped out over it. I was shocked at how good a frozen steak cooked this way. Seeing is believing but there are many ways to skin a cat.
Sounds like it would be a great steak. You got the proper sear on it on the top of the stove and cooked it in a way that would help tenderize. I like it! What kind of steak was it? I'm going to give it a shot when I get up to Austin next month.
 

El Guapo

Cheesehead
Joined
Dec 7, 2011
Messages
7,560
Reaction score
3,031
Location
Land 'O Lakes
Sounds like it would be a great steak. You got the proper sear on it on the top of the stove and cooked it in a way that would help tenderize. I like it! What kind of steak was it? I'm going to give it a shot when I get up to Austin next month.
I bought two ribeyes, but I'm pretty sure it would work with a top sirloin, porterhouse, etc.
 

Members online

No members online now.

Packer Pick'em

GB @ DET
Oct 25, 2026 at 3:25 PM
Make your pick
2 member(s) have picked so far. Picks are revealed at kickoff.
+ 12 more games to pick this week
Season leaders
🥇 DoURant DoURant 200
🥈 Pkrjones Pkrjones 110
🥉 Poppa San Poppa San 85
4 Zartan Zartan 20

Survivor Pool

1 of 4 still standing
Week 7 · last kickoff Oct 26, 2026 at 7:15 PM
Join the pool
Most picked (locked games)
NE @CHI 50%
Top